Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by ernestocat

  1. E

    FlowCode 8 with ATTiny45, Timer

    Hi heureka ! Now It has finished with a happy end .... it works !! The solution lies in the fuse settings. Please see the Attachment. Many thanks for your helpful advices. have a good time and best regards Ernesto
  2. E

    FlowCode 8 with ATTiny45, Timer

    Hi Thanks for info! I will now study the documentation. Yet, as you know, when I load the Tiny45 using the arduino uno as programmer, the FC8 delay works correct. Annotation: That I can use the arduino uno as programmer for Tiny45, I have been to load a special Arduino program to arduino...
  3. E

    FlowCode 8 with ATTiny45, Timer

    Hi Nice to see. Unfortunately, this is not available in version FC8 :-( Unfortunately, the price for each new FC version is very high. Matrix FC upgrades are too expensive. (my mind) Many thanks to you Ernesto
  4. E

    FlowCode 8 with ATTiny45, Timer

    Hi I could not find any mistake. Please note: Setting "AR_Tiny45_DTest_20210816" -> Arduino -> Tiny45 is different to Flowcode 8 -> programmer -> Tiny45 Practice: To test both "Arduino 8 MHz" and "Arduino 1 MHz" I have carried out both settings. Please see results in...
  5. E

    FlowCode 8 with ATTiny45, Timer

    Hi Question: How can I find to your FlowCode Startscreen ? (I actually work with flowcode 8) Thanks and best regards Ernesto
  6. E

    FlowCode 8 with ATTiny45, Timer

    Hi As mentioned I have carried out the Test with Tiny45 via arduino one SMD (please see Attachment) The results -> as expected. Question to Klaus: Where can I find the CODE Button ? Which type of programmer for directly access whould you suggest ? Question to...
  7. E

    FlowCode 8 with ATTiny45, Timer

    Hi Klaus As you suspect, it's generated code by FC8. I don't know why there are so many libraries included!? Whether one of the libraries is the reason for the timer error? I have no idea. One way to find out this, could be to load a (hand written) short On/Off sequence onto the Tiny45 via...
  8. E

    FlowCode 8 with ATTiny45, Timer

    Hi Thank you. Please see the Attachment. Ernesto
  9. E

    FlowCode 8 with ATTiny45, Timer

    Measured: The programmed "Delay"-Time in FlowCode 8 is eg. 1000 ms. The real measured Delay-Time is about 7 seconds. My Question: What have I to do, that the measured time is equal the “Delay-time setting”?
See more

Part and Inventory Search

Back
Top