Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by eramit123456

  1. eramit123456

    Micrprocessor and its application

    Timing Diagram is a graphical representation. It represents the execution time taken by each instruction in a graphical format. The execution time is represented in T-states. Below example will help you...it consist almost all machine cycles.. Timing diagram for STA 526AH. STA means Store...
  2. eramit123456

    my operating system problem

    what kind of virus is in ur system.???
  3. eramit123456

    problem in the phase delay in hfss

    check this thread u might get ur answer..
  4. eramit123456

    my operating system problem

    yes go to drive where u intalled software then program files and copy software which u needed.
  5. eramit123456

    my operating system problem

    copy that softwares from ur program c drive to another drive..
  6. eramit123456

    my operating system problem

    i think you can save your some software only.. you can not save your all software because some software have their files in the WINDOW folder so that software u must install after changing OS.
  7. eramit123456

    PCB soldering, wondering if my iron is suitable

    use flux soldering by using flux solder you can do small soldering very well...
  8. eramit123456

    What is fermi level ? How does this concept works in a semiconductor ?

    I think u got ur 1st answer.. Now about semiconductor In semiconductor There is difference between Fermi level Conduction band and valance band electron is in between Conductor and insulator.. And if add impurity in semiconductor Fermi level of valance or conduction band will be change...
  9. eramit123456

    how to mesure the negative voltage with ADC0804?

    use clapper circuit... it will increase ur dc level so -5 will be 0 and +5 will be +10...
  10. eramit123456

    Analogue circuit simulation in Multisim.

    Make parallel resister conncetion at ur battery and then change ur battery voltage. Now depending upon ur condition u will get different voltage across that resister..
  11. eramit123456

    References about designing CPUs and RAMs

    Re: Want to design a cpu Go for computer hardware cource...
  12. eramit123456

    Creativity From Electronics Componenet(Images)

    ----^^^^^^^--------!!------@@@@@-------- **broken link removed** ----^^^^^^^--------!!------@@@@@-------- **broken link removed** ----^^^^^^^--------!!------@@@@@-------- **broken link removed** ----^^^^^^^--------!!------@@@@@-------- **broken link removed**...
  13. eramit123456

    Triangulation concept

    It is method of finding location by using known location... I think u have equation for finding location and u want to know only what is triangulation. Then go to below link. Click here to know about triangulation
  14. eramit123456

    Bts carrier frequency

    No One BTS uses more than one 200 khz carrier depend on the frequency Reuse factor and cell planning of any compony.. Typically One BTS can Handle 50 to 90 user it also depend on the frequcy reuse factor and how many channel are allocated do perticular company..
  15. eramit123456

    advice required for master program

    I think is your personal Decision but if u get good job after ur bechler then no need to do master but i u want more than go for masters...

Part and Inventory Search

Back
Top