Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i tried that way too..
pad size is changing but in 3d view i could see mask over pad and very small pad which can be soldered.
In above picture as you can see the via property i was talking..
yes @Brian, this is what i want. i wrote pad 1 in wrong place in hurry.
i want to make via same as test point or IC pin pad.
I am preparing single side pcb board. So, for that i will be use jumper on other side. i want to solder wire on this via.
i tried to change the via size but i didn't get...
Hi,
I am designing PCB in kicad. I am trying to change the via pad bit same as IC pin's pad. I didn't get success. i googled but no similar searches.
Here is in picture, i want to make PAD 1 same as PAD 2.
Hi
i am using Kicad for first time. i want to use 7 segment as following.
I didn't found any symbol related to that.
I searched all the symbol. Please mention the symbol name for the above one.
Hi,
i am using 18F2550 and xc8 compiler. i got following warning related to interrupt memory corruption. Here is the warning
:: advisory: (1234) * Corrupted fast interrupt shadow registers
how to avoid this warning.
Re: what can be behavior for 3.3v PIC and 5v display
No. I was talking about uart only by saying TX and RX.
i have connected other sensor(MLX temp sensor) on i2c which also works on 3v3. Sensor is working fine for me.
Re: what can be behavior for 3.3v PIC and 5v display
Thanks. I will try using pull up's first.
But is this stuck behavior is expected after connecting 5v peripheral to mcu works 3v3?
Re: what can be behavior for 3.3v PIC and 5v display
yes i have connected other sensor there which works on 3v3.
In both way i will have to use voltage translator.
Hi,
I am using one display works on 5 volt and interface is UART. And PIC16F886 runs on 3.3volt. what is the behavior if we interface both on uart.
When i connect display to the controller and controller stops working. do i need to use voltage translator for 3.3V and 5V.
Did you installed packages for your controller from keil update package?
If you install those package then only controller will be listed in project wizard.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
