Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Well, so each channel is processed separately. (MUXout): one channel at a time is selected according to the MCU control signal (5 bits so 2^5= 32 possible values)is a peripheral functions of the MCU . The MCU includes also the CPU and Memory. the ADC output for each channel is stored in a...
Re: its not working with me (balanced amplifier, power splitter)
Hi. Are you designing a microwave power amplifier followed by a power splitter using balanced coupler? (90°, 3dB)?(this is what i remark from your ADS schematic
I can understand that the main problem is the noise level present in the analog part before the ADC stage:-x. Improving your signal (reducing the noise) starts by the correct design (and the choosen components) of the amplification stage: NF of the amplifier+ its bandwidth= it should be a low...
Hi. Even i'm late for giving a view poin about the thread, i think that the ADC characteristics are important: the sampling frequency but also its resolution and dynamic range!
What is the range of acquired signals? (the ADC input SNR) to set up a suitable conditionning circuit before the ADC...
Hello. Is it possible to find a xilinx FPGA model kit in order to make a simulation and an analysis with the ADS software? knowing that only the Altera FPGA is available. :sad:
Best regards
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
