Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
[amitkr22]
your question is not clear but I'll Tell you some about interrupts in general that may help you to focus and clarify your question,
--interrupts --> is occurrence of internal or external Signal which interrupts the execution of a program code it makes (by means of internal hardware...
Hi people How are you All ,
I hope you are all fine ,
I think It will be helpful for beginners like me if any/some of the Experienced members make a Complete Comprehensive tutorial that will pinned about the following points related to each of the international standard organizations involved...
Hi All ,
I hope u are fine ,
my question is about Lan's and internet 's Topology and corresponding transmission media and multiple access resolution protocols,
First part : for each of mesh,star,bus,ring topology which one is used for lan and internet practically whether recently or obsolete...
hi people how are you,
hope you are fine
I'd like to ask you where Could I get Documents describing the Standards of SPI and I2C like
Commands on binary level , protocol in general , when a master sends a message to slave and
expects a reply what's the delay for response after the last...
hi all,
I'd like to learn about GSM it's Architecture , modulation , Protocols Every thing , but instead of going and get a book on GSM from amazon or any where i'd like to use the European Telecommunications Standards Institute Standard Documents so I opened the website searched for GSM and...
hi,
Pls what is the at command i should use to cancel any notification from gsm shield especially incoming sms notification....i don't like any reply from the shield except for a given command only it reply when i send a command to it.....thanks
hi,
How make my GSM shield register to the operator network.... pls i want list of ordered commands .... with explanation, I have searched the web and couldn't get an answer ..... thanks in advance
hi my GSM/GPRS shield keep displaying the following message over and over again :
RDY
+CFUN: 1
+ENCRET: 0
+CPIN: READY
what does this mean ?? how to stop that ??
note am using a 9 volt 2A external Adapter
Another problem :when sending AT+CMGS = "phone number"
it gives me
+CMS ERROR...
I need convert a parallel digital 8 -bit input to control the on duration of n5e55 monostable,
i thought of digital potentiometer but i found all serial communication,
is there any parallel ones ?
if not, i think of dac but how to convert analoge voltage to duration of ne555, is there any...
Please I'd like to convert the attached graph from logarithmic to linear scale by taking points and interpolate them , for accurate reasons i'd like not use the given values on x-axis ,y-axis i want to use vernier caliber to measure distances, how to do the scaling and converting,i already know...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.