Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
the problem with the voltage not the programmer or the at mega
i use the file to ge my hex file atmega8_noxtal.zip for this website https://todbot.com/blog/2009/05/26/minimal-arduino-with-atmega8/comment-page-5/
the usb cable give the programmer 5v i put the Cable 5v of the usb in the external power in programmer and the ground in the ground and i check the power was 4.7 v did the power enough or i have to Substitution the usb cable with power supply
i connect the programmer https://electronics-diy.com/avr_programmer.php
with my atmega8l-8pu and i Severed cable USB Drives The computer arrived and external power to the programmer to get 5v from computer but when i bourn the hex file the pany prog tell me Device missing or unknown device...
hello,i used avr programer to program the atmega8l -8pu (https://electronics-diy.com/avr_programmer.php) this is the programmer i have tow kinds of codes
atmega8noxtal.name=ATmega8-noxtal @8MHz
atmega8noxtal.upload.protocol=stk500
atmega8noxtal.upload.maximum_size=7168...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.