Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by Emb4U

  1. E

    [SOLVED] bitrate of nodes in can communication

    According to the calculation of transmitting node ,the receiving node will check wheather the crc calculation will match or not match. If not match then crc error will generated.
  2. E

    [SOLVED] bitrate of nodes in can communication

    NO NO this is wrong, If TEC is not equal to REC then CRC error will not generated because CRC calculation handled by can controller automatically. CRC error will check by receiver. It will check wheather it will match or not match.
  3. E

    CAN-sends its own identifier

    Actually my question is, when a node sends its own ID then there must be a error occurs.I want to know that which error that was. please suggest me some answar
  4. E

    Remote frame in CAN bus....

    Sorry SIr,, I understood completely. Thank you
  5. E

    Remote frame in CAN bus....

    If it happens then node C sends data on whose ID as the answar of remote frame. Help me please
  6. E

    [SOLVED] can-messages with same identifier

    Dear members please help me.
  7. E

    [SOLVED] can-messages with same identifier

    I know that two nodes will never send same ID in same time. It is illegal but may be possible.(mention in document) But as per the document they have seen as identical. then which condition should be arises here. thanks for reply. some suggetions please.
  8. E

    Remote frame in CAN bus....

    Dear FVM sir just think that there is 4 nodes in a CAN bus.(node A, B,C,D) If node A want to know the status of node C. If node A sends the message ID of node C through remote frame then how will node C know that which node sends a request to know the status of node C. Kindly help me..
  9. E

    Remote frame in CAN bus....

    In remote frame means one node will send the request for knowing about the status of another node. then that node will send a remote frame. My question is in that CAN Remote frame the node sends whose identifier in frame ? Means if he send sender's ID then why and recievers ID then why ...
  10. E

    [SOLVED] can-messages with same identifier

    When two nodes sends same identifier in a same time to access to the another node then one node will go to the busoff condition. Then my question is in between two nodes which node will go to busoff ? Dear members please help me because i am totally confused.
  11. E

    CAN-sends its own identifier

    Dear senior members please help me on this.
  12. E

    more than 8 byte of data in CAN

    Dear senior members please help me on this because I want to send more than 8 byte of data in a frame in my project.
  13. E

    busoff in can communication

    Dear FVM sir,u means the node is off , not bus is off for a while.Please sir clear my doubt. thanks for your valuable reply.
  14. E

    busoff in can communication

    As per you when error counter of the node is reached to 256 then it will go to bus off condition. After that all nodes which are connected to the bus also goes to busoff condition. All nodes off means total busoff.Is it right?
  15. E

    busoff in can communication

    If the error counter of a node reaches 256 it goes to busoff condition. My question is busoff condition means," bus is completely off" or "node is completely off in a bus". Please suggest me some answar.

Part and Inventory Search

Top