Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In Potyo2rev1:
I think to replace the transistors BC327 by this smt, BC807. Datasheet here **broken link removed**.
You think that is correct?
En el Potyo2rev1:
Quiero reemplezar los transistores bc327 por el Bc807 Datasheet aqui **broken link removed**
Pensais que seria correcto...
Hello I'm spanish and my english is bad, sorry.
I'm read a lot of pages of this thread because I'm looking for one version of potyo2rev1 on smd/smt version. It's exists?
I try made it for myself but I don't know for what change the bc327 to another on smt version and that value of the resistor...
fuxpio i dont now. The problem of powered pic by icd2clone is the limitation of VCC current (about 100mA BC557).
Put capacitor 100nF between pins 31-32 of 18f4550 and 16f877a too. These capacitors are very important in all pics circuit.
fzanoto
Failed Self Test. See ICD2 Settings (status tab) for details.
this is your problem. Powered your pic and conect vdd y gnd to icd2 to pass the self test. (5v)
Or powered pic by the icd2, enabled this function in options (not recomeded)
Re: Need help to make USB icd2clone work ( 4550 & 877A v
(I'm spanish, my english is bad)
Hello I'M orkney... This isn't my user. I registered now.
Well try to put capacitor "poliester" 100nF between pins 32 and 31 of both pic's.
(soldar condensadores de poliester entre los pins 32 y 31 de...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.