Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
FvM, thanks. Could you send me an example of schematic of this peak detector (for my frequency 5MHz and 10ns pulse width)?
Will this detector be able to see pulses below 100mV?
Yes, it is true PPM. I need to control gain. How to make this using, for example, OP-AMP's or specialized IC? I tested AD8361 but it is sensitive to the pulse position.
Pulse Position Modulation. I need to measure the pulses amplitude to control gain. It must be analog circuit because pulses have only 10 ns width. Next I use ADC to measue DC signal from this circuit.
Hi,
I would like to design analog cirquit dedicated to measure pulse amplitude of PPM signal.
The frequency of signal is 5MHz and pulse width have only 10ns.
Amplitude changes from 10mV to 1,5V <- I must measure it.
During the experiments it turned out that the IC dedicated to measure RMS value...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
