Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi friends
I constructed this machine 1 year ago. Please take a look at:
hxxp://yunus.hacettepe.edu.tr/~alper/maximus/index.htm
(Replace xx with tt)
-----
This web page is designed to present my graduation thesis; printed circuit board drilling machine which was done for Hacettepe University...
Re: PCB milling machine
Hi,
Take a look at:
hxxp://yunus.hacettepe.edu.tr/~alper/maximus/index.htm
(Replace xx with tt)
This web page is designed to present my graduation thesis; printed circuit board drilling machine which was done for Hacettepe University, Electrical and Electronics...
Hi,
I use MSP430F148 or MSP430F149.
Circuit connections are as follows:
DVCC, AVCC are connected to 3V
DVSS, AVSS, VeREF+ (pin10), VREF- (pin11) are connected to GND
RST/NMI pin is tied to VCC over 100K resistor.
Only JTAG interface pins are connected to 14-pin JTAG-Connector
All other pins...
hiddemo.exe
Hi,
Anyone have the USB PC Software and Driver of CCS PIC USB Examples:
For "ex_usb_hid.c" -> hiddemo.exe
For "ex_usb_scope.c" -> oscope.exe and usbdemo.sys
Best regards
pseudo random generator ic
Hi,
I need a "truely random" bit generator ic. It must not be "pseudo random"
I search over the internet but can only find a MCU from Atmel.
If it is possible to be implemented on a single chip, why there is no single ic dedicated for this operation.
Tundra...
Hi,
I am looking for a MSP430 delay calculator or a delay routine.
I tried to write one but i was not very accurate.
It can be in Assembly or IAR-C.
(IAR sucks, you give 1500$ to the compiler and it does not supply even a delay function)
Best regards
Hi,
I have just started using MSP430 with IAR C Compiler.
In my opinion, no words to MCU but for IAR, it is an awful compiler.
CCS for PIC has so many ready routines, so you do not have to learn all the internal registers.
IAR for MSP does not include any routines. So you have to deeply study...
Thanks for the replys.
(to solvarg) I am not looking for a bridge ic, just an interface chip like PCI to Outside World.
I think PLX's 9030 seems the best solution in the given alternates.
Best regards.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.