Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If I am understanding correctly you basically want to connect two nets that are at the same potential (gnd & vss).
I have seen this done several ways.
1) Leave them disconnected until the very last step. Then connect them and ignore the error, make gerbers.
2) Use a zero ohm resistor to do...
I believe that if you run glossing in Allegro it will remove the 90 degree traces not positive though. It is best not to route with 90s. They cause reflections, impedance issues etc.
Erik
eLab Electronics
www.elabelectronics.com
eLab Electronics is an Electronics Design and Consulting Company
Please see our website for more information **broken link removed**
eLab Electronics is here to help you with your electronic design needs. We can play a small advisory roll or, on the other extreme, take a design from an idea in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.