Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Electrical length
Electrical length will be different from physical length, because the velocity of signal in a medium will be less than the velocity of light in free space.
resistor storage
We are looking for purchasing a storage system for SMD (0603, 0805,0402 sizes of various tolerances ) capacitors and resistors and ICs in our lab. Please suggest some products ( storage racks) for this application.
We do not use reels or tape. All components are cut tapes or...
impedance 35
Kindly help to find a source for purchasing flexible coaxial cables of impedance other than 50 and 75.
We need 35 Ohms, 15 Ohms and 25 Ohms cables
thanks in advance
how to remove copper pour from orcad layout
Select the obstacle mode.
draw the shape you want. Then change the prpperties of the obstacle as anti copper. It is there in the selection menu.
Now to see the change. Go to the post process and view the preview of the layer.
You can see the copper...
mobile layer stack up
Do you have any learning material to assist in the layer stack designing and PCB routing of mixed signal PCB, which contains both RF and DSP which handles high speed signals.
For example, PCB design for a mobile phone.
I have been facing very high interference from...
2sc2061 substitute
Please tell the possible equivalent transistors for 2sc2061.
this is used in the power supply of aiwa 14" tv, at the input of STRS6707 IC.
thank you
Two important factors to consider while selecting an ADC are
1. The maximum msps
2. Dynamic range ( numer of bits)
If your information carrying RF signal has a band width of B, then you should select an ADC with at least 2B msps.
Next you consider the ACPR of the specific wireless standard you...
suspended stripline
Hello ,
parameters of suspended stripline can be calculated using MWoffice.
use the susbstrate as SSUBL- twoline stripline substrate. Use S1lin line in the circuit for analysis.
thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.