Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
net ties in altium
Thanks for your answers, but I'm asking for other question.
I've an schematic with 2 grounds (GND and AGND) and I want to route in an independent way, two different nets. Finally I will joint both in one point.
How to do this without 0 ohm resistors?
Thanks.
altium net tie
Does someone know how it is possible to trace separated planes of GND that later join in a concrete point?
How is it possible to do automatically in Atium Designer?
Does somebody know an adjuster of S-file record length? I use the m2ms.exe of Fujitsu Softune but it fills the addresses without data and I should control the adjusting ranges and to compose the final file in a manual way. We make this to program quicker the flash by means of the boot.
Regards
Re: CAN interface does not work with code stored in Flash me
I dont know the C167, but it can be some SFR that you dont init in your application. Some SFR related to clock. You can send one frame and see the CAN with scope.
Re: CAN on pic18f458
Do you have another node in the network? If the transmitter controller does not read a acknowledge (ACK bit dominant) of a receiver, it tries again .
Re: Looking for editor/generator from state diagram to C cod
We have used *isual*tate in applications from 2k to 128k, with different micros, and our experience is very good. I do not believe that be necessary to code in C sentences.
Re: starting with Tricore
We have bought the tc1130 Starter Kit (Triboard) and we will begin to use it. I think that you should begin with a evaluation board.
rs232 vs rs485
I think that the progressively cheaper hardware allows us to use more sophisticated communications with a low cost.
Sometimes the environment imposes the standard.
After a development for automotive I use CANbus in industrial applications.
Do you refer to the spike in the switch ON? This is due to the parasitic capacity of the inductance.
You can supress it with a LP filter after the sense resistor.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
