Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I remeasured the output to TGND, the DMM reads the same, ~ +/-25V
I loaded connected a 10 ohm 3 watt resistor in parallel to pin 3 and 9, then DMM probed pin 1 and pin 11.
SMPS Schematic
https://www.allen-heath.com/media/xone_db4_db2_004_066_psu_2.pdf
Hello there
I have a music mixer failing components downstream from the PSU.
After some investigation, I realized the voltage output from the PSU is higher than specified on the board or schematic.
Output should...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.