Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by Eclipse2007

  1. E

    hilbert transform in simulink

    how to deduct the value of late? the problem is that I have not yet obtained the right Hilbert transform.
  2. E

    hilbert transform in simulink

    i can't juste delayed the signal, i muste obtain the same sequence with a 90° phase shift. Hello, I try to get the Hilbert transformed for a chaotic signal in order to have two signals completely orthogonal -> Chotic signal and Hilbert Transform of chaotic signal in MATLAB all goes well, I...
  3. E

    hilbert transform in simulink

    I just tried it but the signal obtained are not orthogonal to the starting signal, i need it for QCSK modulation, i tried also analytic signal blocks and i take only the imaginary part of the result but i am not satisfied. Hilbert tranform must return the same signal with 90° of dephasage. with...
  4. E

    hilbert transform in simulink

    i need too to know to get hilbert transform in simulink
  5. E

    simulink model of CDSK and QCSK

    No one answer me! I need help please.
  6. E

    CDSK modulation-Obtained Result

    when i tried to do simulation in simulink of CDSK modulation i obtain the following signals 1. data 2. chaotic signal 3. dataxchaotic signal delayed 4. addition of 2 and 3 5. Delayed version of 4 6. product of 4 and 5 7. output of my correlator at reception 8...
  7. E

    simulink model of CDSK and QCSK

    I am a PhD student, I work on digital modulations (CSK, DCSK, CDSK, QPSK, BPSK, QCSK ...), I work mostly on digital modulations based on chaos. However I am in blocking state for more than ten days in my work, I can not get a good BER in my simulation of CDSK modulation. for information, i work...

Part and Inventory Search

Top