Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by echostar

  1. E

    Floquet and lossy material

    Can you try to add a vacumn box over the material and assign the floquet port on it, and then deembed?
  2. E

    Help: HFSS simulating fano resonance using floquent ports

    Dear All, I have tried to using HFSS to simulate the structure in APL 98, 011911, using floquent ports. But the results are quite different from the paper. Would anyone check my model and point out the error? Thanks very much!!
  3. E

    a Lossy Silicon Substrate Property Setting in HFSS for CMOS Technology

    I had a similar experience. Waiting for some help here.
  4. E

    HFSS simulation of on-chip MIM Capacitors

    is 5ohm*cm corresponding to 20simens/m?
  5. E

    (HFSS)sign of Dielectric Loss Tangent??

    I think it should be plus sign
  6. E

    pbg or ebg design with HFSS

    To hntko, Check the field calculator in Hfss, and you will find the definition of refl_raw.
  7. E

    Latest RF tutorial uploaded

    It's wonderful! Thanks for your work!!!
  8. E

    need some example of PIFA design in hfss

    is there any reference for the dualband1withoutfoam.rar? thanks!
  9. E

    What should be the PIFA dimensions of the radiation box for HFSS simulation?

    PIFA in HFSS taebin1111 wrote: The solution type was set to 'driven terminal'. I changed the solution type to 'driven modal' and I got the result what you want. good luck! Different from taebin1111, i delete the port inside and build a new wave port on the selected face of the coaxial, the...
  10. E

    what is the Floquet Port deembed distance mean in HFSS

    So would you please enlighten me about how to set these parameters? My email is nseagull at gmail dot com.
  11. E

    IE3D Help regarding defining the ports

    IE3D Help Usually i will asign the middle part as +port 1, the other two sides as - port 1, just click the left key of the mouse.
  12. E

    Help: how to define a CPW feeding port in FEKO?

    I am using Feko 5.4 Lite, and meeting this problem. Sincere thanks to anybody providing information.
See more

Part and Inventory Search

Back
Top