Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
It seems quite logical that 3D models are mandatory to apply vertical clearance and the procedure to adjust the 3D model height doesn´t seem too complicated, so I´ll try it and post the results, thanks a lot!!!
---------- Post added at 12:55 ---------- Previous post was at 12:48 ----------...
Androm, I think your sollution is a good approach if Altium has no other "correct" way of dealing with components placed at different height than 0 from the board. Even in this case I agree with Kj.singh on the time consuming issue (Though I think that the more complete a component is, the...
I´m designing a board with a display on it, this display will be separated from the board about 20mm with plastic separators. I want to be able to indicate this to Altium since I want to use the space underneath the display to place several components without getting component placement...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
