Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Brad, thanks for the response.
I have been going through dozens of spec sheets. XLR, DIN, milspec and a couple more i forget the names of didnt match.
I just ordered a CNX-505 without spec sheet as a bit of a hail mary.
I can risk 10 bucks. If it doesnt mate, but can handle the current...
Hi guys,
I have been searching for hours on this and cant seem to find a site to source a specific barrel connector for a project.
I want to integrate a foot pedal into a lotos ltp500d plasma cutter torch connection. Its a 3 pin barrel connector. I figured I would just make an inline...
figured out an easy albeit dirty way to control the driver boards. I will leave the existing microcontroller in place and all of the original wiring, except for the thermistors. Those I will clip and wire in a digital potentiometer controlled by the arduino as a replacement. I will just cycle...
Hi I was wondering how you made out with this? I am looking to do the same thing. I have a 2 zone vinotemp, lower is running to cold, looking to replace the existing control panel with an arduino reusing the driver board. The built in controls maxes out at 66deg I would prefer 70 to use as...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
