Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Guys,
I think this might be the solution you are looking for:
To print holes on your PCB artwork
File -> Default Prints
1. Set PCB Prints as your default print
2. Configure PCB print
3. In the "Printout Options" column tick "Holes"
4. Change your printing preferances to mono, this step...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.