Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
I need you help, I have made 3 of these circuit to run a 3-phase induction motor so I want to run them using a single variable resistor,so I want to know which variable resistor can I use?
KerimF,U are a genius. Its working I just remove that 10kOhm on R13 in your circuit and it worked and added LED in series with 1.8kOhm resistor. I don't know how can I thank u,i just wish if u were here in South Africa. God Bless u.
yes I am also using windows 7,everything is working fine.
- - - Updated - - -
Is your explorer IE9? I run it on Windows 7 (home basic)
yes it is working.
No, I have manage to open it,it does open.i can see its working. the output of my Vcc is now read 6V,i think something is not going okay with my circuit.
- - - Updated - - -
i see on R5 you use 12kohm restistor and me i am using 8.2kohm
- - - Updated - - -
tell me do you have proteus program...
I suspect that something is not right, but what confuses me is that all three circuit works the same I think it could be over voltage that a may damage the components.When you do measurement to your circuit do you get the same values that I get?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
