Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for your valuable information..pls explain from which two points I need to measure the insulation resistance?
Earth continuity is between earth pin in power socket to the instrument case right?
As per instructions our instrument surely meets in CLASS I. If I disconnected the protective earth and measure what will be the average voltage between the body to earth. When i measure in this case different multimeter will shows different voltage.Pls refer the attached image in previous...
Pls find the attached image for your reference. Which I have tested in two different multimeter..Here I have noted eractic values which is right or wrong?.
I'm looking to ensure the instrument does not generate any leak voltage or shock free instrument..
Hi all,
Actually I have an instrument to detect component failure.
Which is operated at 230V AC @50HZ. Instrument properly connected earth..when I test earth to neutral voltage it's around 3V AC..
Kindly suggest me how to test the instrument leak voltage..
Is it right way to test the voltage...
Hi all,
Recently in my new PC installed Orcad 16, Installation completed successfully but not able to open the software. I got the below error " lic_error Lmf-02096' error?" kindly suggest me to solve the issue.
Hi All,
I have a coil, it will have the resistance of 1.5Ω. Assume, if the coil is winded 10 turns with clockwise or anti clockwise it will have the same resistance but is it possible to detect it is winded in clockwise or anti clockwise.
Hi All,
I'm looking for this component to replace, It looks like a signal conditioner but i'm not able to get any details about this. Please suggest me where this component available to buy or any other equivalent to replace.
Thanks for your suggestion, I will try that surely. I have an alternate idea too please comment about that how much it will helpful to me. It was connecting ground terminal with the earth, I don't know exactly how it will work. Awaiting for your valuable feedback's..
Hi,
Worst condition Maximum Input Voltage at VB is 28V DC but normal operating voltage is 24V DC. This too also works fine more than 5lakh cycles suddenly got damaged due to the unexpected reason. I'm not able to find the exact reason for broken that diode(TPSMC47A). Is there any way to protect...
Dear All,
I'm facing a issue in the below attached circuit, Here the diode D200 a TVS Diode was broken frequently i don't know the exact reason but it may broken due to any surge voltage. Please suggest me to solve the issue.
Regards,
Kumar.
Hi all,
I'm using orcad16.0, .DSN, .GTD files are opening but .MAX file are not able to open, Kindly suggest me a solution to solve this issue.
Regards,
Santhoshkumar
Thanks you all for your valuable Feedback,
Is there any other options to switch this voltage? As per my application there is a two source voltage(500VAC & 1000VAC) Sometimes it may go to 1500VAC depends upon the variant but its rare to use. For my condition, at a time one voltage only in ON...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
