Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello, I was wondering if I need anything else for this type of setup; like pullup resistors. The transistor needs to be either fully on or fully off. Thanks.
n-channel mosfet
Is there an IC like the LTC4447 that is not so hard to find and that comes in both PDIP and SOIC packages? The LTC4447 also seems to be an obsolete.
mosfet h-bridge
Ok, I think I might have a solution for the top MOSFETS. I hope to use op amps to drive a 17 volt signal into them. This circuit works fine in the simulator, so I hope that it will work empirically. Please let me know if something does not seem feasible with my design.
mosfet h bridge
I'm stumped. I can't seem to get this thing working. I only get a humming noise. No motor movement. My o-scope displays a lot of noise when connected to the motor terminals.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.