Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, Klaus ,
I am not proud to say that but i am using the cheapest thing i can get D2212/920KV 3s/4s.
Checked several times for bad bearings, shorts etc. and it looks like the motor was OK.
Hello guys,
I know this is tread that is pretty much recurring every now and then, but i still don't have the answers needed.
I am using the following schematic(the file is attached) with the following arduino code(also attached).
Using Electronoobs design with little tweaks and the same...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
