Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for the reply.l will try to get the capacitive loading specification. iC-Haus has one very close but not enough voltage.They recommended a cascade transistor to follow but had no design or recommendation.
I would use freeze mist comes in a spray can. When it the problem starts spay the ics. testing for bad connections I use a heavy duty fiberglass rod. Tractor supply has them Zareba 60 in. Fiberglass Rod Post..I cut it down to 12" and round the ends a little.Strong enough to flex the board and...
I need halp in circuit design for a laser driver to control a laser max rated 3 amp 20v, the drive would be a
square wave less than 5ns rise time,vary in width 200-1000ns.
I can use a Phillips PM5139 generator for the drive...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
