Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
Hello, I used your code to test with the UART0 of my system and it didn't work. Then I checked the params you defined at the beginning and realized the UART ID is 0 but the interrupt was set for UART1. I changed it to UART0 and it is perfectly working now:
Just change this:
#define...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
