Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
in my version of appcad all the unknowns to the left have to be given and all the unknowns on the right are found on the click of the button. so i could not find wo
---------- Post added at 13:20 ---------- Previous post was at 13:18 ----------
my operating frequency is 800Mhz L is somwhere...
use a loop and the statement within should be P0.i as in i specifies the pin no of port. another thing use the port which has no other specific application like port 2 in 8051. and use of buzzer or led depends on the application of project as in where u r gonna use it.
can u help me out with appcad as i dont know this software and i have only 20 days remaining to submit the project. Plz it would be of great help to me
if it has to check for all times then use infinite for loop
take the input in a variable and then compare the variable with ff using if loop
if it satisfies the condition give the instruction to move the wagon
for(;;)
{
if(x==255)
;//here give the instruction that will move the wagon
}...
The input impedance of patch is 233 ohms so the impedance of strip line should also be 233 ohms k, but the co-axial cable has impedance of 50 ohms so how to match them without using incept feed
but this pdf does not contain design equations for microstrip feed line. I need the equations for width and length of microstrip line feed. tell me if you have those equations. Thanks for the help
---------- Post added at 15:21 ---------- Previous post was at 15:03 ----------
plz its urgent...
I am designing a microstrip antenna with microstrip line feed technique, I need the equations for the width and length of the microstrip line feed plz help me
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
