Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i am using a thermistor as an input to a pid and ders a set pt fr the same..the set pt acts as another input of pid cntrlr..acording to the difference between both values my heater coil is gettin turned on/off...could i get to know if i can set a range of values say from -1 to+1 fr which i can...
hi..this is the pid controller i am using in my project for temperature controll..the reference voltage used is 5v..i want to know how to tune it to correct reading..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
