Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
When you have embedded tasks to do within a timeframe, you have to do your research, especially if you do not have time come up to speed on a new microcontroller, only to dicover it will not get the job done. Assembly code can be faster than C code, if you do it correctly, but you can write and...
I have reviewed the data sheet for you, and the serial interface is very typical and may be done with any microcontroller. The timing requirements are not difficult at all. The logic is described for both seral read and serial write. While "SPI" might be used, you can easily interface to this...
I could not locate the data on the HMC702LP6E before offering my thoughts on passing serial data, however, usually this can be done with one or more control lines, and may be done with any device which can meet the speed and interface requirements. Microcontrollers from 8 bits to 32 bits may...
I want to place some bare through holes in the circuit board without any metal or pads. How do I do that in ARES 7 Professional? Can that be done?
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
