Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Now SMPS working fine,
I am changed 3 electrolytic capacitors.
On the board that value = 2.2uf 50v, but this is not available in our local market, so I replace it with 2.2uf 63v.
>Before change that Switching voltage in green pin 0.5v, after change green pin voltage 2.9v
Special thanks...
hi, its working last 1year 8months. but now arise the problem.. ..
Company = i ball
Marathon - 500W Peak
What you think, any component is need to change ??
some time with load / when connect to mother board SMPS not on,
in that time remove all connector from mother board - green pin voltage under 2.5 volt, after wait 1 or 2 day when again power on without load, green pin voltage is ok for switch on the SMPS...
What can i do now, & where I am check it
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.