Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear friends,
I want to design an electronic circuit that can control open/close a garage door using remote control
Any suggestion about :
1. the idea 2. schematic
Thanks
wait your help.
Thank you for your interest.
The LCD is working probably, It is initialized well and Display images , but instead of its base point (0,0) , it starts at (0x63,0).
Thanks for your reply,
it gives that warning to the line
Glcd_Image(image1[1024]);
as u expect,
but when i remove the length of image1, it gives me an error of :
Illegal pointer conversion eeprom_read.c at the same line
Glcd_Image() function description
===========================...
Dear sir,
Iam designing with MikroC Program a simple project, i want to write the image to eeprom, i do it successfully , then to load many images from eeprom 24lc512 to pic18f4620 then display it to the graphical lcd.
i display an image to GLCD successfully , but when i write the program to...
I got a strange KS0108B based GLCD (128x64) also
i use JHD12864E Graphic LCD interface with pic18f4420 , but i have a strange phenomna , i have my (0,0) point at 63H address ,
kindly advise is it the problem of LCD itself (but i try 2 LCDs)? or how to adjust the reference point to left upper...
i use JHD12864E Graphic LCD interface with pic18f4420 , but i have a strange phenomna , i have my (0,0) point at 63H address ,
kindly advise is it the problem of LCD itself (but i try 2 LCDs)? or how to adjust the refernce point to left upper side.
iam using MicroC S/W.
wait your reply
Thanks
i use JHD12864E Graphic LCD interface with pic18f4420 , but i have a strange phenomna , i have my (0,0) point at 63H address ,
kindly advise is it the problem of LCD itself (but i try 2 LCDs)? or how to adjust the refernce point to left upper side.
iam using MicroC S/W.
wait your reply
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.