Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you very much for the information provided.
Added after 5 hours 58 minutes:
Hi,
I've one more question related to Ethernet protection. I've a requirement of 16KV injected on M12 connector(used instead of RJ45) pins. and battery protection(Battery voltage: 16.2V to 72V).
Ist a good...
Hi,
Thanks for quick reply. I was referring to CM termination resistor (75ohm with a high voltage capacitors after the Magnetics.) Please refer the attached file Page 9.
Thanks
hi,
i'm working on ethernet for first time and using a industrial M12 connector instead of RJ45. I'm also using a 75ohm termination resistor along with 2KV capacitor. Wanted to know if 0.5W 75ohm resistor is sufficient and also any calculations related to termination resistor calculation is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
