Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, I am hoping to use CST to get the impedance at one end of an asymmetric microstrip as accurate as possible.
The cross section of my microstrip is as shown in attachment.
I am really confused what dimension of waveguide port should be to get an objective and accurate line impedance there...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.