Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am trying to get communication output for CAN protocol. I am using CAN Engine MCP2518FD and CAN Trans-receiver as ATA6561. I couldn't been able to get the output. I have done many projects successfully using CAN protocol but previously I have used CAN Engine MCP2515 and MCP2551 as...
implement an timer for 1 sec using timer
then apply algorithm for trip delay
***
trip delay= 31 - ADC processed o/p
if,trip delay =31 (i.e ADC o/p is 0)
loop up timer for trip delay times to achieve trip delay time
(this logic will only work for ADC o/p ranging from 1-30)
***
make sure that...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
