Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I can't read the circuit very well bu from the layout, I can give you a bit of a description on what's going on.
Top right corner is an LM317 (LM117) adjustable regulator used in it's constant current mode which is set by R2 & R8(cant read it very well)
The regulator in this mode will NOT...
+pin +active low +bar above
Hi Mathgeek,
The bar above the name of a pin means that the signal is active 0V input.
Example: INT (with a bar above it, on some micros) means that to get the interrupt to work, the pin must normally be held high, and when you want an interrupt to happen, the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.