Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
xc888
I was trying to send something to the hyperterminal using the USART. Below is the of the sample code i try. This is the setting of the the hyperterminal: 9600bps baud rate, 0 stop bit, parity bit none and flow control none. But nothing come out in the hyperterminal. Please Help.
Please...
I need a very good tutorial and reading on communication between microcontroller and computer using c in all version of microcontroller, but most of the tutorial i see are in asm. is there any good guide on it thanks.ANy help will be greatly appreciated.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.