Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have seen in many papers that Kubo formula was used to model graphene conductivity at microwave frequencies in CST, but I am not sure how to enter the values into CST. Can anyone please help me with a quick explanation?
Can anyone explain to me how to extract Group delay and Cross Correlation of the UWB antenna in CST?
If there is a template, I would appreciate if you could send it to me.
Thank you!
Output Power, 20 Watts
P1dB Compressed 12 Watts (which is actually 41dBm, sorry)
input return loss of 10dB
NF is not very important (ie 10dB)
Looking forward to your design recommendations. Thank you!
I need to design a linear RF Power amplifier with flat gain of at least 45dB over 20-2500MHz.
flatness +-2dB, P1dB min should be 37dBm, VSWR(in) 2:1
I suppose the technology of choice should be GaN, but could you please recommend the active device and the architecture
that can achieve this...
I am trying to simulate a nanoantenna with a layer of graphene, but I don´t have the complex conductivity model for graphene in cst and hfss and the other problem is that the layer of graphene is only one atom thick (2D).
has anyone done similar simulation in cst or hfss?
How to define boundary conditions for the patch antenna with partial ground in hfss?
Should finite conductivity boundary be assigned to bottom ground face and radiation boundary to top airbox?
@amitsinghjiit
Thank you, but I am not sure that I understood your explanation.
If port P1 is the port attached to the feed of the antenna (upper metalization layer), and port P2 is the port attached to the partial ground (lower metalization layer), does it mean that P1 port type should be...
Is it possible to have a partial ground plane in a simple microstrip patch antenna simulation in ads momentum? I would appreciate if you could explain how to define the layers to achieve this.
Thank you and regards
I want to define and map the layers in order to simulate a microstrip transmission line with a gap with a dice of dielectric that is placed over a gap and touching microstrip line on both sides. I am not sure how to map the layers and whether it is possible to have a dielectric as layer 1, as I...
I have to define the layers in order to simulate a microstrip transmission line with a gap with a dice of dielectric that is placed over a gap and touching microstrip line on both sides. I am not sure whether it is possible to have dielectric as layer 1, as I tried to map (strip) the layer and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
