Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What about using signal from TX pin on tranceiver? You can connect TX to external interrupt pin on MCU. Falling edge on TX will generate an interrupt, which waked up MCU.
Yes, mega32 will work. Still at 1MHz.
To switch to external crystal you should set CKSEL0, CKSEL1, CKSEL2 and CKSEL3 fuses ("set" means "1").
What program do you use to downloading program to MCU?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.