Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
its a 12 volt 20 amps it plugs into a cigarette lighter and i was using a speed control from a tattoo power supply that supposed to go from 1.5 to 18volts
Hi, i have a 12 volt mini air compressor that i converted to use with engraver,, evrything turns on but when i try to connect a speed control to it ,,nothing?? i have tried different speed controls and still nothing? any help would be appreciated
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.