Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi! I just want to ask if is it ok to use a different wavelength when testing a fiber optic cable used for transmission line or for OPGW? For example I am using a singlemode fiber with 1550nm wavelength, is it ok if I will use 1310nm wavelength for testing?
Hi! I know this is quite a very simple question, where we all know that once a circuit is open we can measure a voltage equals to the supply voltage while the current is zero, but I want to fully understand why and how? why is the voltage be equals to the supply voltage at components before the...
Hi! I am working on a PCB design, which is for audio DSP, I want to avoid ground loops. How should I connect the grounds? Where should their common ground connection be? any suggestion guys?
Hi! I would like to sync multiple digital clock using an NTP server and I am want to know if there are any application that can be used to connect to a NTP server?
How To design a clock network with NTP mutlicasting configuration
Hi! I am new with NTP, and I would like to synchronize time setting and display for multiple digital clocks. I have checked few sites but it does not show example for the network/system design. Can you please help me on to start...
Hi! I have to multiple clocks which are from 2 different clock brands, and I want to create a single network among the clocks where I can set the time and will automatically apply to all the clocks. Will a universal Time server a good idea to interconnect the clock? Or do you have any idea on...
Hi! I am trying to load program in PIC16LF1939, but as I connect the PICkit 3 and sets the operating power to 3.3V it give me this message.
Connecting to MPLAB PICkit 3...
Currently loaded firmware on PICkit 3
Firmware Suite Version.....01.39.15
Firmware type..............Enhanced Midrange...
I have attached the schematic and PCB layout for the FTDI and the EEPROM, and so as a screenshot of the FT_prog for the FTDI.. I am thinking right now the possibility of a damaged FTDI, i have tried to replace the EEPROM twice but get the same response;(at the EEPROM) there is No clock pulse at...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.