Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
mosfet switch
A Dummy transistor is the one in which you short source,drain & gate to either VDD or VSS to keep that in off state.
Basically a dummy is used to improve matching by keeping the same environment to the outermost transisitors. A Dummy transistor can avoid over etching or under...
Re: DFM issue ?
Hi,
You have to use DFM(Design for Manufacturability) guide lines in Layout to reduce the chances of occurances of faults (shorts) and to improve YIELD without increasing the area of the layout.
Ex: Redundant contacts, redundant vias, more poly overhang, extra spacing b/w...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.