Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
How can you tune the matching circuit? The copper squares surround the microstrip, and are not tunable.
Could it be a metal filling rule? something like on-chip design rules?
I ran in to this picture of a pcb in a datasheet. It was just weird for me to see this metal pattern on the top layer. Any thoughts on why this exists?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.