Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you again, I'm a little worried because all this seems to me much more complicated than I thought, and I have just a few days available to design, protorype and test this converter....
Please do not forget that the goal of this converter is not to set the dc-link voltage at a specific...
Thank you for your answer treez.
Please let me know: why should I choose a current mode solution and not a simpler voltage mode? The reference for the output voltage will come from the microprocessor, that can make it slowly ramp up to the desired value, based on power feedback. What should be...
Hello everybody.
I need a step-down dc/dc converter to be used as a front end for a 2kW HF-generator.
The input voltage is 320V.
The output voltage will be adjusted directly from the HF-generator CPU in the range from 100V to 300V: the goal is adjusting the HF-generator power just acting on...
Obviously the DC/DC converter operation is based on the feedback coming from a meter that monitors the power flow from/to the AC main. Oscillations are not an issue because every change is very slow.
d123 thank you for your answer. The hardware has already been designed and a protoype is currently under test. My request is about the control strategy to be implemented in the microprocessor.
Good morning everybody,
I'm writing to ask for technical supoprt: i'm developing a bidirectional battery charge regulator for a storage system to be connected in a parallel to a PV array, therefore before the MPPT of the grid connected inverter. The battery charge/discharge management is based...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
