Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Have you ever wondered shashi ,why when you provide reset pin of AT89C51, code execution begins from location 0x0000 .Its bcoz of this firmware running on AT89C51 chip.Firmware is nothing but a startup code permanently stored on uC chip which runs before any of the user program.
In some chip...
p89v51rd2 programmer circuit
Thing is that my circuit is ready. I am using MAX232 & 74LS125 for serial interface.
DTR is goin through 74LS125 & to RESET pin of 89V51RD2.
Even in FLASHMAGIC when I press U I get reply as U.
But when I try to program IC , a window pops up saying RESET device...
Re: uninstall linux
Best Way is to use boot manager which comes Drive parttioning software(Partition Magic or Paragon Partition manager).
It is very easy to use.
Solves all ur booting problems,surely.
Give it a try.
Re: installing linux
Follow these steps:
1.Get some partition manager like Partition Magic Or Paragon Parttion Manager.
2.With this manager create drive with atleast 10GB's ,keep the format as EXT3 & make sure this is PRIMARY Partition & space of drive is at end of the disk.
3.Now...
Re: booting
See Buddy
Reboot & go to BIOS.
Disable on chip Audio,Network support .
If I am not wrong you must be using Intel 945 series motherbords.
If true,then this will solve your problem.
I want to do a project on single master-multi slave communication using I2C protocol. Master is gonna be a 89c51.
I would like to know whether I can use 89c51 as one of the slave.
Plz hlp.
Thanks
Re: multithreading
See,we cannot have infinite threads, because a fiber has a stack, and it is the address space required by the stack that is the limiting factor nearly all of the time.
More you can read on---
**broken link removed**
I don't why u people are making simple problem so complex.
Simply put transmitter in one arm of seat & transmitter in other.
You can use simple IR led for transmission & TSOP1738 for reception.
I hope this'll help.
Bye
interface lcd telephone to rs232 pc
HI
You can use IC CMX866 from CML Microcircuits.
It has inbuilt DTMF generator & a RS232 interfacing facility.
It also has inbuilt AT command interpreter with which you can dial/answer from PC.
I am also attaching PDF for CMX866
I hope this will help.
Bye
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.