Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by cubalibre

  1. C

    The simple way to cut PCB

    Re: Any way to cut PCB?? I have a dremel clone, a mini drill with a lot of accessories. I use it for cut PCB with cutting disks and to make holes. It was not more expensive (about 35 €)
  2. C

    Problem with NoKia 7250 - downloading data

    Re: Problem with NoKia 7250 The only solution I think is a firmware upgrade in a nokia service point . There's possibility you lose all data stored in phone
  3. C

    Tektronix 465M complete manual

    tektronix 465m manual h**p://www.slack.com/pdf/Tek465-op.pdf I don't know if your model and it's incomplete
  4. C

    Req: VCR Panasonic NV-G10

    panasonic nv-g10 Need VCR Panasonic NV-G10 (very old model) schematic / documentation tanks in advice
  5. C

    Comparison of different Press'n'Peel sheetsa

    printing labels on samsung laser printer cracks I tried dwg lucid paper and hot iron but with bad results. Now i make pcb with blue incandescent lamp and 25 min. exposure
See more

Part and Inventory Search

Back
Top