Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello Auato:
I am happy that you've fixed the problem and that my images have been useful in the repair.
I have no schematic of 3SR not the service manual.
If you find them would be grateful if you share with me.
Greetings
COSMOS
Hello
In a few days take pictures with more resolution in the affected area
COSMOS
---------- Post added 31-03-11 at 01:27 ---------- Previous post was 30-03-11 at 23:53 ----------
Hello
I hope these pictures help you repair your 3SR, if you encounter problems send me a message...
Hello
I have a Wavetek 3SR in perfect condition. Disassembled in a few days and I put some pictures of the burned area.
You can see some pictures in this direction
**broken link removed**
**broken link removed**
**broken link removed**
**broken link removed**
**broken link removed**...
Hi:
I know the link because I am a member of that forum. The images that have posted are of poor quality and do not distinguish the component values.
thanks
Greetings
Re: How to Converting coaxial cable Impedance from 75 to 50
Hi:
In TEST equipment if the outputs are set to 50ohm just put a 25 Ohm resistor in series and calculate the insertion loss. (Method recommended by Marconi Instruments)
Regards
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.