Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am not very strong in electronics, maybe my questions are dump. Maybe you can mark in my attached scheme how and where i should place resistors? Also i dont use usb cable from controller to computer. I use bluetooth for controlling plasma table. So there is only three wires which are going in...
Hi,
i am making cnc plasma project. Controller crashes and looses steps when plasma cutter is working. I have few questions about grounding and shielding wires maybe somebody who had same experience can help me with advice how to solve my problem. Thank you for any help.
1.Do i need to ground...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.