Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
I'm looking for a fully protected h bridge, logic level control, 1.7amp or greater current and a supply voltage min of 4v.
The only device I found was drv8800 that was close. but the supply min is 8v.
thanks cool
Hi I'm having problem sending a binary file using mscomm, The code reads a binary file from my hard drive and then sends the file out through the a comm port.
I can read the file, but I cannot send out a byte at a time. I would like to place a slight delay after each byte.
How do I create...
Hi I would like to declare a variable in a data.h and be able to use in other modules.c
--------------------------------------------
data.h
#ifndef _DATA_H_
#define _DATA_H_
int foo = 10;
#endif
--------------------------------------------
#include "data.h"
extern int foo;
void main
{...
Hi I would like to create timing period of 250ns.
then use multiples to create different intervals such as 1us or 10us
Using C is there a method? I can use nop, but for long intervals >100us it would not be pretty.
btw my clk 24mhz,
thanks cool
Hi I'm exploring methods to measure temperature and pressure, My temperature range is between 40- 180 degrees f and and my pressure range is between -10 to 30 psi.
What low cost methods are available?
cool
Hi given a single pole butterworth filter how would one generate the coefficents for a filter (iir). using scilabs?
I plan to use this in a microcontroller, so any help would be appreciated?
thanks cool
Hi I have a design in eagle, on my schematic my nets will not connect to the part. I tried zooming in to place the part on the grid and varies ulp from the eagle site same results. Are there any other solutions?
thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.