Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes, the data sheet of the ADC mentions that the Supply Range is 2.0V up to 5.5V
I do not really know what to expect. After some research I found out that gas sensors have to be calibrated with chemical samples and an adjustable resistor. Nevertheless the fluctuations I see seem strange to me...
I connected the ADC0 input with the 5v pin of the pi but the value is extremely fluctuating. It does not seem to provide usable values. ?
Do you know what the problem might be?
Hello experts!
I am totally new to electronics and I need help with connecting the MQ135 Gas sensor with my raspberry pi 3B+ and with interpreting the data that the sensor provides. My main problem is that the sensor provides analog signals and the RPi 3B+ does not have a pin for analog...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.