Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The waveform of yours consists of 2 frequencys, that is, a carrier frequency and a signal frequency, and the signal frequency usually consists of a multiple-frequency waveform, look at AM Radio Signallings. If you want to lower down such a frequency, the best way is lower down it when you have...
I cannot read the codes for such a diagram in Verilog. If you can take out the connection of the circuits, I can answer you!!
For further contact, you could mail me: <cleveryj@126.com> or <yujiang2016@163.com>!!
Least annoyment it could catch from charge flows such as fast flow of airs, intensity flow of water, and in space, intensive flow of space matters. It requires an protocol to achieve it as every byte transmitted, it needs an One-Byte CRC Check, to see whether the transmitting byte is correct!! I...
In Edge-Connectors, the flat layer of 99.99% gold is covered to have an accurate impendance with the circuit connected on. For instance, 0.2Ohms is required for Blue-Tooth equippments. And the flawness of such devices could not pass up by 0.1%, in such cases!! And as I know, Aerospace...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.