Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Nope. I am looking for the UART.
From my understanding, UART is a protocol. And I am looking for its physical standard like the rise/fall time required, voltage level and etc.
I would like to know what to do to link between schematic and layout.
What I can do currently is when i press the component on schematic, it can highlight the component in layout.
What I want to do is, when I press on the component of layout, it can highlight/bring me to the component in schematic.
I am a newbie to Design For Test. Can I have some material on that?
If I would like to take master by research, is there any interesting topic that I can look into?
hai, where can i find the 2000 pages manual?
i am using the 16.3 but it really bumping my head now. any manual or link for me to learn it from beginning?
Thnx.
but the problem now is when i change the w and l ratio of the PM4 and NM1, the VDS sat of both will increase too. What I want to do is to decrease the Vth of the PM4. Is there any way to do so?
hai, i am now facing a problem on biasing the mos into saturation region.
can anyone help me with it?
The problem is when i bias the NM1 into saturation region, the PM4 will fall back to linear region. And also the other way round...
thank you...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.